- 您现在的位置：买卖IC网 > Sheet目录341 > MAX5078BATT+T (Maxim Integrated Products)IC MOSFET DRIVER 6-TDFN
MAX5078
4A, 20ns, MOSFET Driver
Pin Description
PIN
1
2, 3
4
5
6
—
NAME
IN-
GND
V DD
OUT
IN+
EP
FUNCTION
Inverting Logic-Input Terminal. Connect to GND when not used.
Ground
Power Supply. Bypass to GND with one or more 0.1μF ceramic capacitors.
Driver Output. Sources or sinks current to turn the external MOSFET on or off.
Noninverting Logic-Input Terminal. Connect to V DD when not used.
Exposed Pad. Internally connected to GND. Do not use the exposed pad as the only electrical
ground connection.
Detailed Description
V DD Undervoltage Lockout (UVLO)
The MAX5078A/MAX5078B have internal undervoltage
lockout (UVLO) for V DD . When V DD is below the UVLO
threshold, OUT is pulled low independent of the state of
the inputs. The undervoltage lockout is typically 3.5V with
200mV typical hysteresis to avoid chattering. When V DD
rises above the UVLO threshold, the output goes high or
low depending upon the logic-input levels. Bypass V DD
using a low-ESR ceramic capacitor for proper operation
(see the Applications Information section).
Logic Inputs
The MAX5078A has CMOS logic inputs while the
MAX5078B has TTL-compatible logic inputs. The logic
inputs are protected against the voltage spikes up to
18V, regardless of the V DD voltage. The TTL and CMOS
logic inputs have 300mV and 0.1 x V DD hysteresis,
respectively, to avoid double pulsing during transition.
The low 2.5pF input capacitance reduces loading and
increases switching speed.
The logic inputs are high impedance and must not be left
floating. If the inputs are left open, OUT can go to an
undefined state as soon as V DD rises above the UVLO
Driver Output
The MAX5078A/MAX5078B have low R DS(ON) p-channel
and n-channel devices (totem pole) in the output stage
for the fast turn-on/turn-off, high-gate-charge switching
MOSFETs. The peak source or sink current is typically
4A. The output voltage (V OUT ) is approximately equal to
V DD when in high state and is ground when in low state.
The driver R DS(ON) is lower at higher V DD resulting in
higher source-/sink-current capability and faster switch-
ing speeds. The propagation delays from the noninvert-
ing and inverting logic inputs to OUT are matched to 2ns
typically. The break-before-make logic avoids any cross-
conduction between the internal p- and n-channel
devices, and eliminates shoot-through, thus reducing the
quiescent supply current.
Applications Information
RLC Series Circuit
The driver’s R DS(ON) (R ON ), internal bond/lead induc-
tance (L P ), trace inductance (L S ), gate inductance (L G ),
and gate capacitance (C G ) form a series RLC
circuit with a second-order characteristic equation. The
series RLC circuit has an undamped natural frequency
( ? 0 ) and a damping ratio ( ζ ) where:
threshold. Therefore, the PWM output from the controller
must assume proper state when powering up the device.
The MAX5078A/MAX5078B have two logic inputs, provid-
ing greater flexibility in controlling the MOSFET. Use IN+
? 0 =
1
( L P + L S + L G ) × C G
for noninverting logic and IN- for inverting logic operation.
Connect IN+ to V DD and IN- to GND, if not used.
Alternatively, the unused input can be used as an
ON/OFF function. Use IN+ for active-low shutdown logic
ξ =
2 ×
R ON
(L P + L S + L G )
C G
and IN- for active-high shutdown logic (see Figure 3). See
Table 1 for all possible input combinations.
8
The damping ratio needs to be greater than 0.5 (ideally
1) to avoid ringing. Add a small resistor (R GATE ) in
series with the gate when driving a very low gate-
charge MOSFET, or when the driver is placed away
from the MOSFET.
Maxim Integrated
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
MAX5092EVKIT+
KIT EVALUATION FOR MAX5092
MAX620EWN
IC DVR QUAD HISIDE MOSFET 18SOIC
MAX626CPA+
IC DRIVER MOSFET DUAL 8-DIP
MAX662EVKIT-SO
EVAL KIT FOR MAX662
MAX6947ATE+T
IC LED DRIVER LINEAR 16-TQFN
MAX6948BGWA+T
IC LED DVR PWM GPIO 25WLP
MAX6964ATG+T
IC LED DRIVER LINEAR 24-TQFN
MAX6965ATE+T
IC LED DRIVER LINEAR 16-TQFN
相关代理商/技术参数
MAX5078BATT-T
功能描述:功率驱动器IC 4A 20ns MOSFET Driver RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
MAX5079
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:ORing MOSFET Controller with Ultra-Fast 200ns Turn-Off
MAX5079_09
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:ORing MOSFET Controller with Ultra-Fast 200ns Turn-Off
MAX5079EUD
功能描述:功率驱动器IC RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
MAX5079EUD+
功能描述:功率驱动器IC ORing MOSFET Controller RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
MAX5079EUD+T
功能描述:功率驱动器IC ORing MOSFET Controller RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
MAX5079EUD+TG48
制造商:Maxim Integrated Products 功能描述:ORING MOSFET CONTROLLER WITH ULTRA-FAST 200NS TURN-OFF - Tape and Reel
MAX5079EUD-T
功能描述:功率驱动器IC RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube